2024 Updated Verified IN101_V7 Downloadable Printable Exam Dumps
The Ultimate BICSI IN101_V7 Dumps PDF Review
NEW QUESTION # 42
A third 90-degree bend may be permitted in a conduit run if one of the bends is located within ____ of the cable feed end?
- A. 483mm (19")
- B. 375 mm (15")
- C. 450 mm (18")
- D. 300 mm (12")
Answer: D
NEW QUESTION # 43
Which of the following terms is used to describe mechanical firestop systems?
- A. Endothermic
- B. Ablative
- C. Intumescent
- D. Elastomeric
Answer: D
NEW QUESTION # 44
Which of the following is designed to provide protection from harmful chemicals?
- A. Cut-resistant gloves
- B. Rubber gloves
- C. Leather gloves
Answer: B
NEW QUESTION # 45
A category 8 cable is terminated into category 6A outlets with category 5e patch cords. What is the maximum supported performance level?
- A. Category 7
- B. Category 6A
- C. Category 8
- D. Category 5e
Answer: D
NEW QUESTION # 46
What is the minimum recommended height that should be used when mounting a plywood back board in a telecommunication space?
- A. AFF 150 mm (6")
- B. AFF 300 mm (12") AFF
- C. AFF 200 mm (8")
- D. 100 mm (4")
Answer: C
NEW QUESTION # 47
Which of the following terms describes the ration of the power of the outgoing signal to the power of the reflected signal expressed in decibels?
- A. Return loss
- B. Mutual capacitance
- C. Characteristic impedance
- D. Insertion loss
Answer: A
NEW QUESTION # 48
Which type of optical fiber cable should be color coded with a RED outer cable sheath?
- A. Polarization maintain SM optical fiber
- B. MM optical fiber with 50 um core diameter (laser-optimized)
- C. MM optical fiber with 50 um core diameter
- D. Dispersion-shifted SM optical fiber
Answer: D
NEW QUESTION # 49
What is the characteristic impedance of Series-6 coaxial cable?
- A. 100 ohms
- B. 75 ohms
- C. 50 ohms
- D. 25 ohms
Answer: B
NEW QUESTION # 50
Which of the following items may be used as a substitute device for a pulling eye?
- A. Wire mesh grip
- B. Innerduct
- C. Fan-out kit
- D. D rings
Answer: A
NEW QUESTION # 51
Which of the following should be used to install plywood in a telecommunications room if the edge of the board does NOT align with the wall studs?
- A. Toggle bolts
- B. Galvanized screws
- C. Metal nails
Answer: A
NEW QUESTION # 52
What is the maximum number of work areas that a CP should serve?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: D
NEW QUESTION # 53
What is the primary purpose of the telecommunications bonding infrastructure?
- A. Equalize potentials between metallic surfaces and equipment within entrance facilities
- B. Provide backup power to the telecommunications equipment when primary power to the equipment fails.
- C. Improve the performance of the installed telecommunications equipment
Answer: A
NEW QUESTION # 54
What is the maximum permissible amount of untwisting for category 5e cable and higher?
- A. 12.7 mm (0.5")
- B. 25 mm (1")
- C. 38 mm (1.5")
- D. 75 mm (3")
Answer: A
NEW QUESTION # 55
During a retrofit, an installation crew discovers old insulation that they think may contain asbestos, they cannot complete their work without disturbing the insulation. What is the best course of action for the crew to take?
- A. Monitor the air quality while they work
- B. Stop work immediately
- C. Wear breathing protection during the task
- D. Remove the asbestos-containing substance
Answer: B
NEW QUESTION # 56
Which of the following is used to measure the length of a 4-pair cable?
- A. Pair scanner
- B. Tone generator
- C. Time domain reflectometer (TDR)
- D. Cable-end locator kit
Answer: C
NEW QUESTION # 57
A purple backboard should be used to identify ________?
- A. Demarcation point
- B. Common equipment
- C. Network connections
- D. Horizontal cable
Answer: B
NEW QUESTION # 58
......
Achive your Success with Latest IN101_V7 Exam: https://www.actual4exams.com/IN101_V7-valid-dump.html