A Fully Updated 2023 H12-831-ENU Exam Dumps - PDF Questions and Testing Engine [Q28-Q43]

Share

A Fully Updated 2023 H12-831-ENU Exam Dumps - PDF Questions and Testing Engine

Easy Success Huawei H12-831-ENU Exam in First Try

NEW QUESTION 28
What is the meaning of the display current-configuration I include vlan command?

  • A. View the IP address of the VLANIF interface
  • B. View all configurations that contain the \VLAN\ keyword
  • C. Check which VLANs are currently created
  • D. View the physical interface information bound under each VLAN

Answer: B

 

NEW QUESTION 29
Which descriptions about the MPLS forwarding mechanism are correct? (Multiple choice)

  • A. If the Tunnel ID value is not 0x0
  • B. When an IP packet enters the MRLS domain, the first thing to look at is the FIB table
  • C. If the Tunnel ID value is 0x0
  • D. The system automatically assigns an ID to the upper-layer application using the tunnel

Answer: B,D

 

NEW QUESTION 30
An engineer uses two routers to test IPv6 services, and simulates the interconnection between the headquarters and branches by running BGP4+.


As shown in the figure, an engineer captures the packet to view the update message sent by R1. Regarding the description of the message information, which of the following statements is correct?

  • A. The next hop address of the route described in this packet is :2001:db8::2345:1.:1
  • B. The route described in this packet may be imported through import
  • C. This packet describes the currently withdrawn IPv6 route
  • D. The routing address prefix described in this packet and its prefix length are :2001:db8:2345:1::1/128/

Answer: D

 

NEW QUESTION 31
According to this figure, what can we judge?

  • A. The IS-IS interface type of the GE0/0/1 interface of R1 is Level-1
  • B. IS-IS IPv6 is not enabled on the GE0/0/1 interface of R1
  • C. The IS-IS interface type of the GE0/0/0 interface of R1 is Level-1-2
  • D. IS-IS IPv6 is enabled on the GE0/0/0 interface of R1

Answer: C

 

NEW QUESTION 32
There are many types of LDP messages. Which of the following functions can a session message implement? (Multiple choice)

  • A. Terminate the outstanding Label Request Message
  • B. Monitor the integrity of the TCP connection of the LDP Session
  • C. Release Tag
  • D. Negotiate parameters during LDP Session establishment

Answer: B,D

 

NEW QUESTION 33
The operation process for putting the equipment on the shelf is to prepare the tools first, then install the mounting ears, install the floating nuts and slides according to the site conditions, and finally install the equipment to the cabinet.

  • A. True
  • B. False

Answer: A

 

NEW QUESTION 34
Ethernet is a network that supports broadcasting. Once there is a loop in the network, this simple factory broadcasting mechanism will cause catastrophic consequences. Which of the following phenomena may be caused by loops? (Multiple choice)

  • A. When running the display interface command on the device to view interface statistics, it is found that the interface receives a large number of broadcast packets
  • B. Serious packet loss when testing the network through the ping command
  • C. The device cannot log in remotely
  • D. The CPU usage exceeds 70%

Answer: A,B,C,D

 

NEW QUESTION 35
The session-based stateful inspection firewall has different processing flows for the first packet and subsequent packets. Which of the descriptions of the flow is correct? (Multiple choice)

  • A. When the stateful inspection mechanism is enabled, when the firewall processes TCP packets, only SYN packets can establish a session.
  • B. When a packet arrives at the firewall, it will look up the session table. If there is no match, the firewall will process the first packet.
  • C. When the state check mechanism is turned on, subsequent packets also need to be checked for security policies.
  • D. When the packet reaches the firewall, it will look up the session table, and if it matches the firewall, the subsequent packet processing process will be performed.

Answer: A,B,D

 

NEW QUESTION 36
If the BFD session goes down, the direct link will fail.

  • A. FALSE
  • B. TRUE

Answer: A

 

NEW QUESTION 37
Which statement is true about ASPF and Server-map? (Multiple choice)

  • A. After the channel is established, the message is still forwarded according to the Server-map
  • B. Server-map is usually only used to check the first message, and the message after the channel is established is still forwarded according to the session table
  • C. The server-map entry will be deleted after a certain aging time because there is no packet matching. This mechanism ensures that the looser channel such as the Server-map entry can be deleted in time, which ensures the security of the network. When a new data connection is subsequently initiated, the establishment of the Server-map entry will be re-triggered
  • D. Only ASPF will generate the Sever-map table

Answer: B,C

 

NEW QUESTION 38
What are the discard policies not included in the congestion avoidance mechanism? (Multiple choice)

  • A. RED
  • B. WFQ
  • C. FIFO
  • D. WRED

Answer: B,C

 

NEW QUESTION 39
Which description is correct about the DHCP address pool? (Multiple choice)

  • A. Only when the address allocation method based on the global address pool is configured, can you set the P address range that does not participate in automatic allocation
  • B. Configuring the interface-based address assignment method will only respond to the DHCP request of the interface
  • C. Configure interface-based address allocation, which can respond to all ports receiving DHCP requests
  • D. Configure the address allocation method based on the global address pool, which can respond to DHCP requests received by all ports

Answer: B,D

 

NEW QUESTION 40
BFD is only a general fast detection technology, which can realize fast switching function by itself, and it is not necessary to use it together with other fast switching technologies.

  • A. True
  • B. False

Answer: B

 

NEW QUESTION 41
When deploying MPLS/BGP IP VPN, which of the following descriptions is wrong regarding the use of BGP to exchange routing information between PE-CE?

  • A. In the case of CE multi-homing, enabling BGP AS number replacement may cause routing loops. BGP SoD can be used to prevent routing loops in VPN sites.
  • B. When BGP is used to exchange routing information between PE and CE, if the autonomous systems where the two VPN sites are located use the same private AS number, the AS number replacement function can be used to replace the received private AS number with any specified AS number. The AS number in the network route to prevent the route from being discarded due to repeated AS numbers
  • C. When BGP is used to exchange routing information between PE and CE, there is no need to import private network routes into BGP on PE.
  • D. In the Hub&Spoke scenario, when Hub-CE and Hub-PE use IGP, Spoke-PE and Spoke-CE cannot use EBGP

Answer: B

 

NEW QUESTION 42
The routing policy tools that BGP can use mainly include Filter-policy and Route-policy, of which Fiter-policy can only filter routes, and Route-policy can only modify routes.

  • A. FALSE
  • B. TRUE

Answer: A

 

NEW QUESTION 43
......

H12-831-ENU Study Material, Preparation Guide and PDF Download: https://www.actual4exams.com/H12-831-ENU-valid-dump.html

Best H12-831-ENU Exam Dumps for the Preparation of Latest Exam Questions: https://drive.google.com/open?id=1Xx4lgWctrnMkP0u7QMjw8nP82RrMsYKu