[Jul-2021] Updated HPE Product Certified HPE2-W09 Exam Questions BUNDLE PACK
Master The HP Content HPE2-W09 EXAM DUMPS WITH GUARANTEED SUCCESS!
NEW QUESTION 41
You are configuring Ethernet Ring Protection Switching (ERPS) on an ArubaOS-CX switch. Is this a guideline for configuring timers?
Solution: The wait to restore timer (WTR) Is set in units of minutes; you can set it to prevent frequent topology changes due to a link going up and down.
- A. No
- B. Yes
Answer: A
NEW QUESTION 42
Is this a best practice when positioning ArubaOS-CX switches in data center networks?
Solution: Deploy Aruba CX 6300 switches as data center spine switches.
- A. No
- B. Yes
Answer: B
NEW QUESTION 43
Your task is to configure an EVPN solution for a dual-stack IPv4 and IPv6 protocol in the overlay networks. Is this statement about EVPN and IPv6 correct?
Solution: The IPv6 and IPv4 overlay networks can be encapsulated with VXLAN and transmitted through the underlay network.
- A. No
- B. Yes
Answer: A
NEW QUESTION 44
Switch-1 and Switch-2 are AruDaOS-CX switches, which ate part of a Virtual Switching Extension (VSX) fabric. Switch-2 is the primary member. Switch-2 experiences a power failure while Switch-l remains up. Switch-2's power recovers, and Switch-2 reboots.
Solution: Switch-2 wails a period called the link-up delay before it enables Switched Virtual Interfaces (SVls) on its VSX LAGs.
- A. No
- B. Yes
Answer: B
NEW QUESTION 45
A customer's servers use ISCSI, and they send data and storage traffic on the same pair of I OGbE links. Is this a best practice for supporting the ISCSI requirements?
Solution: Set up dedicated switches to connect to iSCSl arrays. Connect top of rack (ToR) switches, which will support both data and storage traffic, to those dedicated switches.
- A. No
- B. Yes
Answer: B
NEW QUESTION 46
You enter this command on an ArubaOS-CX switch:
Switch# show erps status ring 1
Is this what the specified status means?
Solution: The status is Protection, which means that the ring is up and fully connected with the RPL port blocked.
- A. No
- B. Yes
Answer: A
NEW QUESTION 47
Does this correctly describe how the Virtual Switching Extension (VSX) fabric reacts to various component failure scenarios?
Solution: The keepalive goes down, ISL link remains up. Switch-1 and Switch-2 remains up. The Split-recovery mode is disabled. In this case the secondary switch shutdowns Svls.
- A. No
- B. Yes
Answer: A
NEW QUESTION 48
Does this correctly describe the ArubaOS-CX architecture?
Solution: The AtubaOS-CX software is based on the ArubaOS-Switch software and adds data center features.
- A. No
- B. Yes
Answer: A
NEW QUESTION 49
You are using NetEdit to manage AruDaOS-CX switches. You want to deploy a standard config to the switches, but need the config to include a few device-specific settings such as hostname and IP address.
Is this what you should do?
Solution: Inside a configuration plan, light-click any device-specific parameters and modify the parameter per-device.
- A. No
- B. Yes
Answer: A
NEW QUESTION 50
Is this a use case for disabling split-recovery mode on ArubaOS-CX switches in a Virtual Switching Extension (VSX) fabric?
Solution: You are not concerned about split Drain Issues in your environment, so you want the secondary member to keep its links up if the ISL falls.
- A. No
- B. Yes
Answer: B
NEW QUESTION 51
Does this correctly describe routing information advertised by a VXLAN Tunnel Endpomt (VTEP) that uses EVPN?
Solution: MAC/IP advertisement routes advertise the MAC addresses that can be reached through the VTEP.
- A. No
- B. Yes
Answer: A
NEW QUESTION 52
Is this a use case for implementing Enhanced Transmission Selection (ETS) on an ArubaOS-CX switch?
Solution: ensures a minimum bandwidth guarantee between two endpoints traffic with various 802.1 p values.
- A. No
- B. Yes
Answer: A
NEW QUESTION 53
Is this a use case for implementing Enhanced Transmission Selection (ETS) on an ArubaOS-CX switch?
Solution: to help the switch to look inside tunneled traffic and apply different quality of service (QoS) settings to different types of traffic
- A. No
- B. Yes
Answer: A
NEW QUESTION 54
Refer to the exhibit.
Switch-1 and Switch-2 ate ArubaOS-CX switches that implement VXLAN WITHOUT Ethernet VPN (EVPN). Switch-2 uses the same VNI-to-VLAN mappings as Switch-1. Is this how the specified servers communicate?
Solution: The first time that Server I communicates with Server 3, It sends an ARP request to resolve Server 3's MAC address.
- A. No
- B. Yes
Answer: B
NEW QUESTION 55
Is this a rule for configuring schedule profiles on an ArubaOS-CX switch?
Solution: With the exception of a single strict priority queue, all queues must use the same scheduling algorithm.
- A. No
- B. Yes
Answer: B
NEW QUESTION 56
Is this a way that a data center technology can help meet requirements for multi-tenancy?
Solution: Virtual Extensible LAN (VXLAN) provides millions of IDs to scale for the needs of a multi-tenant environment
- A. No
- B. Yes
Answer: A
NEW QUESTION 57
Refer to the exhibit.
which shows the topology tot an Ethernet Ring Protection Switching (ERPS) solution.
Is this a valid design for the control and protected VLANs on the VSX fabric 1 switches?
Solution: Ring l, instance 1:
control VLAN: 1000 protected VLANs: 51-135 Ring 1, Instance 2:
control VLAN: 1000 protected VLANs: 136-220 Ring 2, Instance 1: control VLAN: 1001 protected VLANs: 181 -200 Ring 2, Instance 2: control VLAN: 1001 protected VLANs: 201 -220
- A. No
- B. Yes
Answer: B
NEW QUESTION 58
Refer to the exhibit.
You are adding a VLAN 30, subnet 10.0.30.0/24 to the network shown in the exhibit. (This network is simplified to just the relevant switches for this item.) This subnet belongs in VRF A, and you have added a Layer 3 VLAN 30 interface attached to this VRF on Switch-1. You want to make the services in this VLAN available to devices in 10.1.20.0/24 in VRF B.
Is this part of a valid setup for meeting these requirements?
Solution: Add a route with this command: ip route 10.1.20.0/24 vlan20 vrf A
- A. No
- B. Yes
Answer: A
NEW QUESTION 59
Refer to the exhibit.
Switch-1, Switch-2, and the router run OSPF on LAG 100, which is a Layer 3 LAG. Does this correctly explain how to control how core-to-access traffic Is forwarded?
Solution: To reduce the amount of traffic sent over the ISI between Switch-1 and Swltch-2. enable active forwarding on LAG 100 on both Switch-1 and Switch-2.
- A. No
- B. Yes
Answer: B
NEW QUESTION 60
Refer to the exhibit.
The company wants AtubaOS-CX switches to provide VXLAN services for several VMs and servers, as shown in the exhibit. Hypervisors will not run VXLAN for this solution. Is this part of a valid configuration to meet the requirements?
Solution: Work with the server admins to assign a consistent VLAN for VMs 1 and 4. Assign interface 1/1/2 on Switch-1 to the same VLAN.
- A. No
- B. Yes
Answer: A
NEW QUESTION 61
Refer to the exhibits.
Is this how the switch-1 handles the traffic?
Solution: A broadcast arrives in VLAN 10 on Switch-1. Switch 1 forwards the frame on all interfaces assigned to VLAN 10, except the incoming interface. It encapsulates the broadcast with VXIAN and sends it to 192.168.1.3, out not 192.168.1.2.
- A. No
- B. Yes
Answer: B
NEW QUESTION 62
You are configuring Ethernet Ring Protection Switching (ERPS) on an ArubaOS-CX switch. Is this a guideline for configuring timers?
Solution: The guard interval is set in units of seconds and is used to prevent frequent topology changes due to a link going up and down.
- A. No
- B. Yes
Answer: A
NEW QUESTION 63
......
Pass HP HPE2-W09 Exam – Experts Are Here To Help You: https://www.actual4exams.com/HPE2-W09-valid-dump.html