[Oct 30, 2021] DES-DD23 Test Prep Training Practice Exam Questions Practice Tests [Q10-Q29]

Share

[Oct 30, 2021] DES-DD23 Test Prep Training Practice Exam Questions Practice Tests

Exam Questions Answers Braindumps DES-DD23 Exam Dumps PDF Questions

NEW QUESTION 10
What rule must be followed during an upgrade procedure with the FS25 expansion shelf?

  • A. If ES40 SAS shelves are on the same chain as an FS25, the maximum number of shelves on that chain is five
  • B. FS25 shelf is cabled on a separate private chain
  • C. For high performance, the connections from a controller to FS25 shelves must be over FC cables
  • D. FS25 shelf must be on the same chain with DS60

Answer: B

Explanation:
Reference: https://www.dell.com/support/kbdoc/en-pk/000082030/71624-memory-requirements-Product Questions: Version: and-storage
https://www.dell.com/support/kbdoc/en-pk/000082030/71624-memory-requirements-Product Questions: Version: and-storage- configurations

 

NEW QUESTION 11
Refer to the exhibit.

Match each action to its call-out location.

Answer:

Explanation:

 

NEW QUESTION 12
What is the correct sequence of steps to configure storage for Dell EMC Cloud Tier in the DD System Manager?

Answer:

Explanation:

 

NEW QUESTION 13
Which protocol is used for communications between a PowerProtect DD appliance and cloud tier to Dell EMC ECS?

  • A. FTP
  • B. SSH
  • C. HTTPS
  • D. SSL

Answer: C

 

NEW QUESTION 14
What is the maximum capacity for a DDVE?

  • A. 256 TB
  • B. 96 TB
  • C. 64 TB
  • D. 128 TB

Answer: A

 

NEW QUESTION 15
What are some key benefits of performing backups and recoveries with a PowerProtect DD appliance?

  • A. Increase in the overall size and scope Elimination of physical tape Fewer copies that need to be tracked Increased speed of disaster recovery
  • B. Reduction in the overall size and scope Elimination of physical tape Fewer copies that need to be tracked Increased speed of disaster recovery
  • C. Increase in the overall size and scope Elimination of physical tape Number of copies that do not need to be tracked Increased speed of disaster recovery
  • D. Reduction in the overall size and scope Elimination of physical tape Number of copies that do not need to be tracked Increased speed of disaster recovery

Answer: A

 

NEW QUESTION 16
What can be used to monitor system utilization?

  • A. Alert Messages
  • B. system status command
  • C. Health tab in the System Manager GUI
  • D. system show performance command

Answer: A

 

NEW QUESTION 17
The finance department requires PDFs older than 90 days to be archived through Cloud Tier into Azure Blob Storage. They want any PDFs older than 180 days archived into AWS S3.
Which data movement policy is used to archive files into Azure Blob Storage?

  • A. Age-range
  • B. App-driven
  • C. Recall
  • D. Age-based

Answer: D

 

NEW QUESTION 18
A customer needs a backup system to protect 100 TB of mission-critical dat a. What should be used to back up the system?

  • A. cloud tier
  • B. DD3300
  • C. DDVE
  • D. DD6900

Answer: A

 

NEW QUESTION 19
What is a requirement to use the PowerProtect DD HA feature?

  • A. Dual set of shared storage configuration
  • B. Each head unit requires its own FS25 shelf
  • C. Head units and nodes require an active/active configuration
  • D. A single set of shared storage

Answer: A

 

NEW QUESTION 20
When using the DD VTL Tape Out to Cloud feature, which status will a tape show once it is in the cloud tier vault?

  • A. Offline
  • B. Vaulted
  • C. Offsite
  • D. Archived

Answer: B

 

NEW QUESTION 21
When the PowerProtect DD system boots up for the first time, the CLI configuration wizard script does not start automatically.
Which command can be used to start the script manually?

  • A. setup config
  • B. configure terminal
  • C. config setup
  • D. config wizard

Answer: C

 

NEW QUESTION 22
Refer to the exhibit.

To which shelf and port should SAS HBA slot 1 port B be connected?

  • A. Shelf 01 BH
  • B. Shelf 04 BE
  • C. Shelf 04 BH
  • D. Shelf 01 BE

Answer: C

 

NEW QUESTION 23
An administrator monitors the performance statistics of a PowerProtect DD appliance. Low disk-write rates are shown, and the network inbound traffic is high.
What is the most likely cause of this behavior?

  • A. Disk failure
  • B. Known segments
  • C. NVRAM failure
  • D. Expired segments

Answer: B

 

NEW QUESTION 24
An administrator recognizes poor network performance when using CIFS shares from a PowerProtect DD system. The network link utilization is under 100%.
What is the most likely cause of this issue?

  • A. TCP timeout too small
  • B. TCP window size too large
  • C. TCP window size too small
  • D. TCP timeout too large

Answer: A

 

NEW QUESTION 25
What happens to the data when it is moved from the active tier to cloud tier?

  • A. It is deduplicated and stored in a file system in the native format
  • B. It is compressed and stored as object storage in a new format
  • C. It is deduplicated and stored in object storage the native format
  • D. It is compressed and stored in block storage in a new format

Answer: C

 

NEW QUESTION 26
An administrator is migrating their old cloud tier-enabled Data Domain to a new PowerProtect DD appliance with cloud tier. During migration, the administrator recognizes that file system cleaning on the source system is not possible.
What is the most likely cause of this behavior?

  • A. Migration will restrict all activities on source systems.
  • B. Source system is running in restricted mode.
  • C. Migration will restrict all activities on both systems.
  • D. Filesystem is disabled on source system.

Answer: A

 

NEW QUESTION 27
Which of the following protocols are supported by PowerProtect DD for data movement to a cloud provider?

  • A. FTP and FTPS
  • B. CIFS and NFS
  • C. VTL and DD Boost
  • D. HTTP and HTTPS

Answer: B

 

NEW QUESTION 28
What is the order of steps to configure DD Boost on the backup host?

Answer:

Explanation:

 

NEW QUESTION 29
......


EMC DES-DD23 Exam Syllabus Topics:

TopicDetails
Topic 1
  • Identify and describe various Dell EMC PowerProtect DD software options and the functionality they enable
  • Manage system access and describe and configure autosupport, Support bundle, SNMP, and Syslog
Topic 2
  • Verify hardware and analyze and interpret space utilization and compression graphs
  • Distinguish between key backup software components
Topic 3
  • Install and configure Dell EMC PowerProtect DD systems with Dell EMC Cloud Tier, including system racking and cabling
  • Monitor system activity and performance and evaluate the cleaning frequency
Topic 4
  • Implement and validate the PowerProtect DD system as a VTL
  • Identify typical Dell EMC PowerProtect DD backup and recovery solutions and describe PowerProtect DD product positioning
Topic 5
  • Describe how to perform the initial configurations of the Dell EMC PowerProtect DD system
  • Describe Dell EMC Cloud Tier features, benefits, architecture and use cases
Topic 6
  • Monitor PowerProtect DD capacity and estimate storage burn rate
  • Implement Dell EMC PowerProtect DD system with key protocols, including NFS/CIFS, DD Boost, VTL, and NDMP
Topic 7
  • Describe how to prepare the Dell EMC PowerProtect DD system for installation, including rail and rack the system hardware, and connect and cable the system to external storage
Topic 8
  • Configure the network for administrative access, and verify interoperability with connected devices
  • Cloud Tier Implementation and Administration

 

Download Free EMC DES-DD23 Real Exam Questions: https://www.actual4exams.com/DES-DD23-valid-dump.html

DES-DD23 Exam Dumps, DES-DD23 Practice Test Questions: https://drive.google.com/open?id=16ZhJDtAzhzDOQeLXArqrq2KVYDa5ULHB