[2021] Valid NSE4_FGT-6.4 test answers & Fortinet NSE4_FGT-6.4 exam pdf
Verified NSE4_FGT-6.4 dumps Q&As - Pass Guarantee or Full Refund
How to study the Network Security Professional (Fortinet NSE4_FGT-6.4) Professional Exam
Test Preparation teaches how the exam questions can to be decoded. Our Exam Preparedness: Fortinet NSE4_FGT-6.4â Technical arrangement course is delivered in multiple configurations: study hall preparing for learning or taking an interest in a physical homeroom with an NSE4 Approved Learner. Free media preparing for learning whenever it is suitable for you. The course surveys test inquiries in each branch of knowledge and how the themes tried ought to be seen to such an extent that off base answers are easier to stay away from. Our course will help you in tracking down the correct answers.
FORTINET NSE4_FGT-6.4 practice test can be used for preparation.
NEW QUESTION 32
Refer to the exhibit showing a debug flow output.
Which two statements about the debug flow output are correct? (Choose two.)
- A. The default route is required to receive a reply.
- B. The debug flow is of ICMP traffic.
- C. A new traffic session is created.
- D. A firewall policy allowed the connection.
Answer: B,C
NEW QUESTION 33
Examine this PAC file configuration.
Which of the following statements are true? (Choose two.)
- A. Browsers can be configured to retrieve this PAC file from the FortiGate.
- B. All requests not made to Fortinet.com or the 172.25.120.0/24 subnet, have to go through altproxy.corp.com: 8060.
- C. Any web request fortinet.com is allowed to bypass the proxy.
- D. Any web request to the 172.25.120.0/24 subnet is allowed to bypass the proxy.
Answer: A,C
NEW QUESTION 34
Refer to the exhibit.
The exhibit contains a network diagram, virtual IP, IP pool, and firewall policies configuration.
The WAN (port1) interface has the IP address 10.200.1.1/24.
The LAN (port3) interface has the IP address 10 .0.1.254. /24.
The first firewall policy has NAT enabled using IP Pool.
The second firewall policy is configured with a VIP as the destination address.
Which IP address will be used to source NAT the internet traffic coming from a workstation with the IP address 10.0.1.10?
- A. 10.200.1.100
- B. 10.200.1.10
- C. 10.200.1.1
- D. 10.200.3.1
Answer: C
NEW QUESTION 35
A network administrator wants to set up redundant IPsec VPN tunnels on FortiGate by using two IPsec VPN tunnels and static routes.
*All traffic must be routed through the primary tunnel when both tunnels are up
*The secondary tunnel must be used only if the primary tunnel goes down
*In addition, FortiGate should be able to detect a dead tunnel to speed up tunnelfailover Which two key configuration changes are needed on FortiGate to meet the design requirements? (Choose two,)
- A. Configure a higher distance on the static route for the primary tunnel, and a lower distance on the state route for the secondary tunnel.
- B. Enable Dead Peer Detection.
- C. Configure a lower distance on the static route for the primary tunnel, and a higher distance on the static route for the secondary tunnel.
- D. Enable Auto-negotiate and Autokey Keep Alive on the phase 2 configuration of both tunnels.
Answer: B
NEW QUESTION 36
Refer to the exhibit.
Based on the administrator profile settings, what permissions must the administrator set to run the diagnose firewall auth list CLI command on FortiGate?
- A. Read/Write permission for Log & Report
- B. Read/Write permission for Firewall
- C. Custom permission for Network
- D. CLI diagnostics commands permission
Answer: C
NEW QUESTION 37
A network administrator has enabled full SSL inspection and web filtering on FortiGate. When visiting any HTTPS websites, the browser reports certificate warning errors. When visiting HTTP websites, the browser does not report errors.
What is the reason for the certificate warning errors?
- A. The browser requires a software update.
- B. FortiGate does not support full SSL inspection when web filtering is enabled.
- C. The CA certificate set on the SSL/SSH inspection profile has not been imported into the browser.
- D. There are network connectivity issues.
Answer: C
NEW QUESTION 38
What inspection mode does FortiGate use if it is configured as a policy-based next-generation firewall (NGFW)?
- A. Certificate inspection
- B. Flow-based inspection
- C. Full Content inspection
- D. Proxy-based inspection
Answer: D
NEW QUESTION 39
Refer to the exhibit.
The exhibit contains a network diagram, firewall policies, and a firewall address object configuration.
An administrator created a Deny policy with default settings to deny Webserver access for Remote-user2. Remote-user2 is still able to access Webserver.
Which two changes can the administrator make to deny Webserver access for Remote-User2? (Choose two.)
- A. Set the Destination address as Deny_IP in the Allow-access policy.
- B. Enable match vip in the Deny policy.
- C. Set the Destination address as Web_server in the Deny policy.
- D. Disable match-vip in the Deny policy.
Answer: A,D
NEW QUESTION 40
Refer to the exhibit.
Which contains a session diagnostic output. Which statement is true about the session diagnostic output?
- A. The session is in FTN_WAIT state.
- B. The session is in ESTABLISHED state.
- C. The session is in FIN_ACK state.
- D. The session is in SYN_SEXT state.
Answer: B
NEW QUESTION 41
Refer to the exhibit.
A network administrator is troubleshooting an IPsec tunnel between two FortiGate devices. The administrator has determined that phase 1 fails to come up. The administrator has also re-entered the pre-shared key on both FortiGate devices to make sure they match.
Based on the phase 1 configuration and the diagram shown in the exhibit, which two configuration changes will bring phase 1 up? (Choose two.)
- A. On HQ-FortiGate, disable Diffie-Helman group 2.
- B. On Remote-FortiGate, set port2 as Interface.
https://www.fast2test.com/NSE4_FGT-6.4-practice-test.html 15
Valid Fast2test NSE4_FGT-6.4 Exam PDF Dumps - New NSE4_FGT-6.4 Real Exam Questions - C. On both FortiGate devices, set Dead Peer Detection to On Demand.
- D. On HQ-FortiGate, set IKE mode to Main (ID protection).
Answer: A,C
NEW QUESTION 42
Refer to the exhibit to view the firewall policy.
Which statement is correct if well-known viruses are not being blocked?
- A. The action on the firewall policy must be set to deny.
- B. Web filter should be enabled on the firewall policy to complement the antivirus profile.
- C. The firewall policy does not apply deep content inspection.
- D. The firewall policy must be configured in proxy-based inspection mode.
Answer: C
NEW QUESTION 43
Refer to the exhibit.
In the network shown in the exhibit, the web client cannot connect to the HTTP web server. The administrator runs the FortiGate built-in sniffer and gets the output as shown in the exhibit.
What should the administrator do next to troubleshoot the problem?
- A. Capture the traffic using an external sniffer connected to port1.
- B. Execute a debug flow.
- C. Run a sniffer on the web server.
- D. Execute another sniffer in the FortiGate, this time with the filter "host 10.0.1.10"
Answer: B
NEW QUESTION 44
Refer to the exhibits. Exhibit A shows system performance output. Exhibit B shows a FortiGate configured with the default configuration of high memory usage thresholds.
Based on the system performance output, which two statements are correct? (Choose two.)
- A. Administrators can access FortiGate only through the console port.
- B. FortiGate has entered conserve mode.
- C. Administrators cannot change the configuration.
- D. FortiGate will start sending all files to FortiSandbox for inspection.
Answer: C,D
NEW QUESTION 45
Refer to the exhibit, which contains a session diagnostic output.
Which statement is true about the session diagnostic output?
- A. The session is a UDP unidirectional state.
- B. The session is a bidirectional UDP connection.
- C. The session is a bidirectional TCP connection.
- D. The session is in TCP ESTABLISHED state.
Answer: B
NEW QUESTION 46
Examine the exhibit, which contains a virtual IP and firewall policy configuration.
The WAN (port1) interface has the IP address 10.200.1.1/24. The LAN (port2) interface has the IP address
10.0.1.254/24.
The first firewall policy has NAT enabled on the outgoing interface address. The second firewall policy is configured with a VIP as the destination address.
Which IP address will be used to source NAT the Internet traffic coming from a workstation with the IP address 10.0.1.10/24?
- A. 10.200.1.10
- B. 10.200.1.1
- C. 10.0.1.254
- D. Any available IP address in the WAN (port1) subnet 10.200.1.0/24
Answer: A
Explanation:
Explanation
https://help.fortinet.com/fos50hlp/54/Content/FortiOS/fortigate-firewall-52/Firewall%20Objects/Virtual%20IPs.
NEW QUESTION 47
Which statement correctly describes NetAPI polling mode for the FSSO collector agent?
- A. The NetSessionEnum function is user] to track user logouts.
- B. The collector agent uses a Windows API to query DCs for user logins.
- C. The collector agent must search security event logs.
- D. NetAPI polling can increase bandwidth usage in large networks.
Answer: A
NEW QUESTION 48
......
Fortinet NSE4_FGT-6.4 Exam Syllabus Topics:
| Topic | Details |
|---|---|
| Topic 1 |
|
| Topic 2 |
|
| Topic 3 |
|
| Topic 4 |
|
| Topic 5 |
|
| Topic 6 |
|
| Topic 7 |
|
| Topic 8 |
|
| Topic 9 |
|
| Topic 10 |
|
NSE4_FGT-6.4 Exam Questions – Valid NSE4_FGT-6.4 Dumps Pdf: https://www.actual4exams.com/NSE4_FGT-6.4-valid-dump.html